“if-else” statement: An “if” statement is used to evaluate the test expression inside the parenthesis; it is followed by optional “else” statement that executes when the “if” condition is false.

Question

Want to see the full answer?

Answer 1

Question

Chapter 3.5, Problem 3.5.1CP

Program Plan Intro

“if-else” statement:

An “if” statement is used to evaluate the test expression inside the parenthesis; it is followed by optional “else” statement that executes when the “if” condition is false.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Draw a flowchart of a Body Mass Index (BMI) calculator, which receives input of user's height (meter) and weight (kg). The calculator will display the BMI Category based on the BMI value as shown in Table 1. The BMI formula is given Q2 as follows: BMI = weight/(height ) TABLE 1: BMI Categories BMI Values BMI Categories Less than 16.0 Severely Underweight Underweight Normal Weight Overweight 16.0 to 18.5 18.6 to 25.0 25.1 to 30.0

Write a flowchart and pseudocode like this: Pseudocode: Start inputmyNumber Set myAnswer-myNumber * 10 output myAnswer 1.The Dash Cell Phone Company charges customers a basic rate of $5 per month to send text messages. Additional rates are as follows: The first 100 messages per month, regardless of message length, are included in the basic bill. An additional three cents are charged for each text message after the 100th message, up to and including 300 messages. An additional two cents are charged for each text message after the 300th message. Federal, state, and local taxes add a total of 14 percent to each bill. THANKYOUU

Write a program that prints the insurance fee to pay for a pet according to the following rules: (Note: must use a switch statement to determine pet fee) A dog that has been neutered costs $50.A dog that has not been neutered costs $80.A cat that has been neutered costs $40.A cat that has not been neutered costs $60.A bird or reptile costs nothing.Any other animal generates an error message. The program should prompt the user for the appropriate information: a character code for the pet type, and a yes/no response for the neutered status. Use a code letter to determine the kind of animal (i.e. D or d represents a dog, C or c represents a cat, B or b represents a bird, R or r represents a reptile, and anything else represents some other kind of animal). Use a code letter to determine the neutered status(i.e. Y or y represents yes, N or n represents no). The user should be allowed to enter the input in either upper or lower case. It prints out the type of animal (full name of animal)…