Explain the reason why direct current (DC) controller can be called as a counter emf controller.
Answer to Problem 1SQ
DC controller can be called as a counter emf controller because the counter emf of the armature is used for controlling the motor acceleration.
Explanation of Solution
In DC motor, the generated counter electromotive force is proportional to the speed of the motor for constant field. The counter emf can differ from the applied voltage only by armature drop.
DC controller can automatically adjust the starting time intervals, based upon the connected load. If heavy load is connected, it has more inertia to overcome; therefore, long time is required to generate the counter emf. When the DC motor starts, counter emf produced across the armature is very low. As the acceleration of motor increases, the counter emf increases. If the voltage value across the armature reaches a particular value, the starting resistance can be reduced at the correct time by actuating the relay. Therefore, the counter emf is mainly responsible to control the acceleration of motor.
Conclusion:
Thus, the DC controller can be called as a counter emf controller because the counter emf of the armature is used for controlling the motor acceleration.
Want to see more full solutions like this?
Chapter 46 Solutions
Electric Motor Control
- What are some recent advancements in control systems. Explain your answer in detail.arrow_forwardExplain the Modeling of electro-mechanical control system?arrow_forwardIn order for the control system given in the figure to be stable, within which limits should the controller parameter K be.arrow_forward
- 2. Discussed briefly the effects of the different types of compensators in control systems.arrow_forwardthe controller function Gc(s) = 2s id a proportional controller true or flase?arrow_forwardPart 1: Process Diagram for Open-Loop Control Systems An open-loop control system can process an input condition to produce an output. Fill in the controller and the plant for each process shown below. Input Control Output Controller Plant Light On, Control Light On Toasted Bread Toasted Bread Control What can be added in the process diagrams to verify the desired output has been achieved?arrow_forward
- Name each curve in terms of control mode in the following graph. And discuss the advantages and disadvantages of each mode. Add the on/off control curve to graph. y Set point Timearrow_forward2. What is the scan chain? How is it used to help observability and controllability to achieve design for testability?arrow_forwarda) Maximum overshoot will be less than 5% and settling time less than 2 secondsDesign the controller accordingly. b)What type of controller is the controller you are designing (P, PI, PD, PID) andWrite down the parameters of this controller according to your calculations. c)Can the controller you designed meet the required values in item a?Please explain.arrow_forward
- What type of feedback controller is shown in figure A. PD controller B. PI controller C. Type 2 D. Type 1 Ve + Vref Vo R₁ R4arrow_forwardExplain in your own words the concept of control modes. Discuss the meaning of each of the four terms fully, how it is calculated and give the unique contribution that it makes to the response of a controller.arrow_forwardWhat are the different types of displacement sensors? Give some uses of displacement sensors.arrow_forward
- Electricity for Refrigeration, Heating, and Air C...Mechanical EngineeringISBN:9781337399128Author:Russell E. SmithPublisher:Cengage Learning