Electric Motor Control
Electric Motor Control
10th Edition
ISBN: 9781133702818
Author: Herman
Publisher: CENGAGE L
bartleby

Concept explainers

Question
Book Icon
Chapter 56, Problem 1SQ
To determine

Explain the procedure to engage and disengage the magnetic clutch.

Expert Solution & Answer
Check Mark

Explanation of Solution

Discussion:

The clutches provide smooth start for the motors and engage the large motors to their loads. The clutches are able to control electrically. The clutches are categorized as single-face clutch and multiple-face clutch.

The single-face clutch consists of two discs that are field member and armature member. The field winding disc (field member) is an electromagnet. The field member and the armature member are brought together by applying the current to the field winding disc through slip rings (collector). The friction is produced when the current is applied to the field member and that friction tightly pulls the field member toward the armature member. That is, the clutches are engaged by applying the current to the field member through slip rings.

The field member and the armature member are mechanically disconnected by removing the current to the field member. That is, the clutches are disengaged by removing the current to the field member.

Refer Figure 56-3 in the textbook for the principle of operation of electrically controlled clutches.

Conclusion:

Thus, the procedure to engage and disengage the magnetic clutch is explained.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Students have asked these similar questions
list the probable causes if the armature does not release after the magnetic starter is de-energized?
(B)- Indicate whether the following statements are true or false and correct the false statements 1- Wave wound armature has two parallel paths. 2- The current ratio is equal to 1/ turn ratio at no-load while the voltage ratio is equal to 1/ turn ratio at full load 5.4. 3-When a series de motor is operated without a load, the armature draws excessive current Ph 4- The hysteresis loss can be minimized by using core of thin laminations ل لهول 259 Ne 02
23. When the circuit breaker is always tripping, most likely There is an overloading c. The supply line are open a. b. There is an over current d. The load is removed 24. The synchronous motor is not inherently self- starting because the rotating magnetic field does not have enough poles b. the rotating magnetic field is produced by only 50 HZ frequency currents the force required to accelerate the rotor is to the synchronous speed in an instant is d. the starting devices to accelerate the rotor to near synchronous speed is absent 25. Synchronous motor has speed a. slight drop in speed on full load b.high speed at low torque а. с. c. constant speed d. low speed at high -
Knowledge Booster
Background pattern image
Electrical Engineering
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Electric Motor Control
Electrical Engineering
ISBN:9781133702818
Author:Herman
Publisher:CENGAGE L
Text book image
Electricity for Refrigeration, Heating, and Air C...
Mechanical Engineering
ISBN:9781337399128
Author:Russell E. Smith
Publisher:Cengage Learning
Text book image
EBK ELECTRICAL WIRING RESIDENTIAL
Electrical Engineering
ISBN:9781337516549
Author:Simmons
Publisher:CENGAGE LEARNING - CONSIGNMENT