Concept explainers
The angle between oscillating plane and y axis.
Answer to Problem 11.180P
Explanation of Solution
Given information:
According to problem
The first derivative of motion is equal to velocity,
The first derivative of velocity is equal to acceleration,
Calculation:
According to given information,
Differentiate to find velocity,
Differentiate to find acceleration
Solve and rearrange,
Now, find the vector
Therefore,
The angle
But, we know that,
Therefore,
According to above figure,
The angle
Then,
Therefore,
Conclusion:
The angle
Want to see more full solutions like this?
Chapter 11 Solutions
Vector Mechanics For Engineers
- Given that P=120lb and Q=130lb, find the rectangular representation of P+Q.arrow_forward3. The bar shown rotates about the z-axis. Find the velocity and accleration of point P for the instant when the angular aceleration is 4 rad/s² and angular velocity is 1.5 rad/s, both in the directions shown. Give your answers in terms of the given Cartesian coordinates. Note: This problem is trying to fool you. The position vector re must be normal to the axis of rotation, which is not from point O. α 0! 500 mm, p 50 mm 200 mmarrow_forward3. Find the velocity of point C if the object below rotates about the line AB (A and B are fixed points) with a spin rate of 3 r/s clockwise when viewed from point B looking toward A. 9 in. 20 in. 12 in.arrow_forward
- Linkage BC of the three-bar linkage is 10 cm in length. At the instant shown, it forms an angle of 45° with respect to Linkage AB. Where is the instantaneous center of Linkage BC located? Вarrow_forward| Link BC has a mass mgc = 4 kg, with a moment of inertia about its mass center of: laac = maclic Link AB has a mass mAR = 2.4 kg, with a moment of inertia about point A of: The wheel at point C is of negligible mass. At the moment pictured below, the velocity of point C is 1.5 m/s to the right. Find the velocity of pin B after link AB has rotated through 90°.arrow_forwardA rod of length 12 cm moves with its ends always touching the coordinate axes. Determine the equation ofthe locus of a point P on the rod, which is 3 cmfrom the end in contact with the x-axis.arrow_forward
- An aeroplane makes a complete half circle of 70 metres radius, towards left, when flying at 500 km per hr. The rotary engine and the propeller of the plane has a mass of 600 kg and a radius of gyration of 0.3 m. The engine rotates at 2500 r.p.m. clockwise when viewed from the rear. Find the gyroscopic couple on the aircraft.arrow_forward3 The object below can rotate in the plane of the page about a fixed axis at A. The object is symmetric about A in the vertical and horizontal directions. A time=0, the object is rotating counterclockwise at 5 rad/s. The material has a uniform area density of 120 kg/m². a. What is the mass moment of inertia of the object about Point A? b. The net moment applied about Point A is shown on the graph. What is the angular velocity, w₁5, of the object at t-15 seconds? MA [Nm] 16 0.15 m 120 kg/m² 0.3 m H wo = 5 rad/s A 0.8 m 0.3 m 0.6 m 0 -8 0.15 m 10 15 time [s]arrow_forwardThe piston of the hydraulic cylinder gives pin A a constant velocity v = 2.1 ft/sec in the direction shown for an interval of its motion. For where r = OA. the instant when = 54%, determine , r, 0, and 6.1" ✓ Answers: r = r = 0 = ÿ = i -1.6989 i 1.9645 i 2.425 10.623 ft/sec ft/sec² rad/sec rad/sec²arrow_forward
- 6. In the linkage below, the angular velocity of link 2 is 100 rad/s CCW. The linkage dimensions are given. When 02 is 90°, find 03, w3, and the velocity magnitude of point C on link 3 by using analytical method. A*A= 1.75 in A*B = 2.5 in AC = 5 in 02 B 3 Y 03 12 02 3 В A*arrow_forward450 B A rigid red of length L = 2.6 ft is position against two surfaces, as Shown. Given that, at the instant shown, the velocity of end A is V₁ = 7.6 fils down slope, find, at this instant : (mag and direc) and direc) (a) the rod's angular velocity w (b) the velocity V₂ of end B (mag B Use the decomposition method. (That is, draw and use a GPMDE.)arrow_forwardThe inverted crank-slider shown has crank AB 3 in and ground link AC = 6 in. Find the re-rocking angle AO, of rod 4 between its extreme right and extreme left positions. Write your answer in degrees but do not write the units. A C DELLarrow_forward
- International Edition---engineering Mechanics: St...Mechanical EngineeringISBN:9781305501607Author:Andrew Pytel And Jaan KiusalaasPublisher:CENGAGE L