Organic Chemistry - Standalone book
10th Edition
ISBN: 9780073511214
Author: Francis A Carey Dr., Robert M. Giuliano
Publisher: McGraw-Hill Education
expand_more
expand_more
format_list_bulleted
Question
Chapter 3.2, Problem 5P
Interpretation Introduction
Interpretation:
The activation energy for the rotation about the
Concept introduction:
In case of butane, the anti conformation has the least energy while the eclipsed conformation has the highest energy.
The rotation of the bond due to which different conformations arise requires gain of energy.
The gauche and anti conformers have only a slight difference in energy, but their interconversion occurs through an intermediate eclipsed conformation.
This requires energy equal to the activation energy.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Draw a structural formula for the one constitutional isomer of the
unbranched alkane C7H16 in which the longest carbon chain has 4
atoms.
• You do not have to consider stereochemistry.
• You do not have to explicitly draw H atoms.
• In cases where there is more than one answer, just draw
one.
(5) For the formula of C5H12O, (a) show your calculation and determine the degrees of unsaturation present, and (b) draw four of the structural/constitutional isomers possible for the formula.
Calculate strain energy for the conformer
pictured below, using strain energy
increments from the table Strain Energy
for Alkanes \table[[Interaction /
1
Compound,k-ol, kca-ol
m
H3C.
J
m
H
CH3
CH3
CH3
H
Chapter 3 Solutions
Organic Chemistry - Standalone book
Ch. 3.1 - Identify the alkanes corresponding to each of the...Ch. 3.1 - Find the conformations in Figure 3.4 in which the...Ch. 3.2 - Sketch a potential energy diagram for rotation...Ch. 3.2 - Acetylcholine is a neurotransmitter in the central...Ch. 3.2 - Prob. 5PCh. 3.5 - The heats of combustion of ethylcyclopropane and...Ch. 3.8 - Prob. 7PCh. 3.10 - The following questions relate to a cyclohexane...Ch. 3.10 - Draw the most stable conformation of...Ch. 3.11 - Prob. 10P
Ch. 3.11 - Prob. 11PCh. 3.12 - Based on what you know about disubstituted...Ch. 3.12 - Write structural formulas for the most stable...Ch. 3.14 - Cubane (C4H8) is the common name of the polycyclic...Ch. 3.14 - Prob. 15PCh. 3.14 - Prob. 16PCh. 3.14 - Prob. 17PCh. 3.14 - Prob. 18PCh. 3.15 - Prob. 19PCh. 3 - Give the IUPAC names of each of the following: (a)...Ch. 3 - Draw Newman projections for the gauche and...Ch. 3 - Identify all atoms that are (a) anti and (b)...Ch. 3 - Prob. 23PCh. 3 - Prob. 24PCh. 3 - Prob. 25PCh. 3 - Prob. 26PCh. 3 - Prob. 27PCh. 3 - Prob. 28PCh. 3 - Oxidation of 4-tert-butylthiane proceeds according...Ch. 3 - The following are representations of two forms of...Ch. 3 - Draw (a) a Newman projection of the most stable...Ch. 3 - Write a structural formula for the most stable...Ch. 3 - Sight down the C-2-C-3 bond, and draw Newman...Ch. 3 - Prob. 34PCh. 3 - Sketch an approximate potential energy diagram for...Ch. 3 - Prob. 36PCh. 3 - Even though the methyl group occupies an...Ch. 3 - Which do you expect to be the more stable...Ch. 3 - Arrange the trimethylcyclohexane isomers shown in...Ch. 3 - Identify the more stable stereoisomer in each of...Ch. 3 - One stereoisomer of 1,1,3,5-tetramethylcyclohexane...Ch. 3 - One of the following two stereoisomers is...Ch. 3 - In each of the following groups of compounds,...Ch. 3 - The heats of combustion of the more and less...Ch. 3 - The measured dipole moment of ClCH2CH2Cl is 1.12D....Ch. 3 - Prob. 46PCh. 3 - Prob. 47PCh. 3 - Prob. 48DSPCh. 3 - Prob. 49DSPCh. 3 - Prob. 50DSPCh. 3 - Prob. 51DSPCh. 3 - Prob. 52DSPCh. 3 - Prob. 53DSP
Knowledge Booster
Similar questions
- In a time-resolved picosecond spectroscopy experiment, Sheps, Crowther, Carrier, and Crim (Journal of Physical Chemistry A, Vol. 110, 2006; pp. 30873092) generated chlorine atoms in the presence of pentane. The pentane was dissolved in dichloromethane, CH2C12. The chlorine atoms are free radicals and are very reactive. After a nanosecond the chlorine atoms have reacted with pentane molecules, removing a hydrogen atom to form HCl and leaving behind a pentane radical with a single unpaired electron. The equation is Cl (dcm) + C5H12(dcm) HCl(dcm) + C5H11 (dcm) where (dcm) indicates that a substance is dissolved in dichloromethane. Measurements of the concentration of chlorine atoms were made as a function of time at three different concentrations of pentane in the dichloromethane. These results are shown in the table. (a) Determine the order of the reaction with respect to chlorine. (b) Determine whether the reaction rate depends on the concentration of pentane in dichloromethane. If so, determine the order of the reaction with respect to pentane. (c) Explain why the concentration of pentane in dichloromethane does not affect the data analysis that you performed in part (a). (d) Write the rate law for the reaction and calculate the rate of reaction for a concentration of chlorine atoms equal to 1.0 M and a pentane concentration of 0.23 M. (e) Sheps, Crowther, Carrier, and Crim found that the rate of formation of HCl matched the rate of disappearance of Cl. From this they concluded that there were no intermediates and side reactions were not important. Explain the basis for this conclusion.arrow_forward(5) One of Prof Cunningham's former students wrote his doctoral dissertation about a new technology to clean up soil contaminated by certain types of chemicals. One of the chemicals we tested in the lab was 1,2,4,5-tetrachlorobenzene (TECB). (a) Draw the chemical structure of 1,2,4,5-tetrachlorobenzene. (b) When we started working on the project, we thought maybe TeCB would be de- stroyed according to first-order kinetics, but we weren't sure. Below are two tables of actual data that the student collected in the laboratory. The two data sets were collected under different experimental conditions. For each of the two experiments, determine if the disappearance of TeCB is zero-order, first-order, second-order, or something else. Specify the value of the rate constant (ko, k1, or k2, as appropriate). Be sure to give the right units of k! Table 1: Concentration of TECB vs. time, experiment 1 time (min) Conc. (mg/L) 10 20 30 45 5.0 2.93 2.06 0.61 0.28 0.057 Table 2: Concentration of TECB…arrow_forwardhow many double bonds would C2H2Cl2F2 have?arrow_forward
- Palmitoleic acid, a fatty acid with various pharmaceutical applications, is mainly obtained from macadamia nuts. The condensed structural formula for a triacylglycerol containing three palmitoleic acid units is provided below. Which of the following statements is NOT true regarding this triacylglycerol? O || CH,−O−C–(CH,)–CH=CH—(CH2)5–CH3 O || CH−O−C−(CH2)–CH=CH–(CH,)5–CH3 O CH,−O−C−(CH,)–CH=CH–(CH,)5–CH, O Its name is glyceryl tripalmitate or tripalmitin. O It is most likely to be liquid at room temperature. O It is an oil (not a fat). O It contains 3 molecules of the same unsaturated fatty acid.arrow_forwardمسلم H2SO4arrow_forwardSimple substitution reactions, CR3X + Z CR3Z + X often occur by one of two pathways, either a one-step mechanism or a two-step mechanism. (The R in the reaction can be a wide variety of C-containing groups that do not participate in the reaction.) Researchers run a substitution reaction in which an intermediate is observed. What, if anything, did they learn about the mechanism?arrow_forward
- In an advanced analytical chemistry lab, a team analyzing a compound 'Q' known to be a structural isomer of octane (C8H18). To determine the specific structure of 'Q', a series of spectroscopic analyses are performed. The sequence of the analysis involves: Infrared (IR) spectroscopy, which indicates the absence of functional groups like alcohols, ketones, and carboxylic acids. Nuclear Magnetic Resonance (NMR) spectroscopy, showing signals indicative of only methyl and methylene groups, with no evidence of methine (CH) or quaternary carbon environments. Mass spectrometry (MS), revealing a fragmentation pattern consistent with branched alkane structures. Based on this sequence of analyses, what is the most likely structure of compound 'Q'? Options: A. 2,2,4- Trimethylpentane B. n-Octane C. 2-Methylheptane D. 3-Ethylhexane Don't use chatgpt please provide valuable answerarrow_forwardIodide ion reacts with chloromethane to displace chlorideion in a common organic substitution reaction: I⁻+CH3Cl →CH3I+Cl⁻ (a) Draw a wedge-bond structure of chloroform and indicatethe most effective direction of Iattack.(b) The analogous reaction with 2-chlorobutane [FigureP16.107(b)] results in a major change in specific rotation asmeasured by polarimetry. Explain, showing a wedge-bondstructure of the product.(c) Under different conditions, 2-chlorobutane loses Clin arate-determining step to form a planar intermediate [FigureP16.107(c)]. This cationic species reacts with HI and then losesHto form a product that exhibits no optical activity. Explain,showing a wedge-bond structure.arrow_forwardComplete the sentence to make it true. The single most important contribution to the stability of a water soluble globular protein's conformation appears to be the sum of free energies of formation of many weak interactions among the hundreds of amino acids in a protein. entropy increase from the decrease in the number of ordered water molecules forming a solvent shell around the unfolded protein. sum of free energies of formation of many weak interactions between a protein's polar amino acids and surrounding water. maximum enthalpy increase from ionic interactions between the ionized amino acids in a protein. stabilizing effect of hydrogen bonding in a protein between the carbonyl group of one peptide bond and the amino group of anotherarrow_forward
- Your chemistry professor draws a number of molecules on the board: (1) CH4 ; (2) H2C=CH2 ; (3) H2C=C=CH2 ; and (4) H2C=C=C=CH2. You muse about all the molecules that chemists draw on a two-dimensional board and wonder which ones are actually planar, existing basically as they appear on the board, and which ones are not plane but rather three-dimensional. Answer ALL of the following questions. What are the specific orbital overlaps (i.e., sp3-sp3) that are in each of the molecules? What are the bond angles for each central atom in each molecule? Which molecules are planar and which are non-planar?arrow_forwardSketch cis and trans structures for polychloroprene. Use two-dimensional Schematics.arrow_forwardPolymers can be cross-linked using a variety of reactions that create connections between different parts of the same polymer chain. Consider the repeat unit of the polystyrene derivative shown below.The homopolymer formed from this monomer has a low ceiling temperature (meaning it readily reverts to its monomers) and is unstable. It can be cross-linked by adding the terephthaloyl chloride (shown below) and AlCl3. Modify the structures provided to draw the result of the reaction of one repeat unit of the polymer with one unit of this cross-linking compound. Do not include lone pairs.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Organic ChemistryChemistryISBN:9781305580350Author:William H. Brown, Brent L. Iverson, Eric Anslyn, Christopher S. FootePublisher:Cengage Learning
Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage Learning
Organic Chemistry
Chemistry
ISBN:9781305580350
Author:William H. Brown, Brent L. Iverson, Eric Anslyn, Christopher S. Foote
Publisher:Cengage Learning
Chemistry: The Molecular Science
Chemistry
ISBN:9781285199047
Author:John W. Moore, Conrad L. Stanitski
Publisher:Cengage Learning