Check Your Understanding Handheld calculators often use small solar cells to supply the energy required to complete the calculations needed to complete your next physics exam. The current needed to run your calculator can be as small as 0.30 mA. How long would it take for 1.00 C of charge to flow from the solar cells? Can solar cells be used, instead of batteries, to stall traditional internal combustion engines presently used in most cars and trucks?
The time taken for the
Answer to Problem 9.1CYU
The time taken for the
Explanation of Solution
Given:
The charge in the solar cell is
The current is
Formula used:
The flow of the current is given by,
Calculation:
The flow of the current is calculated as,
The stator of the traditional internal combustion engine required the large amount of current in a very short period of time. But the solar cells provide small amount of current for the large period of the time. Therefore, the solar cells are not used to starts the traditional internal combustion engines.
Conclusion:
The time taken for the
Want to see more full solutions like this?
Chapter 9 Solutions
University Physics Volume 2
Additional Science Textbook Solutions
Physics for Scientists and Engineers with Modern Physics
Conceptual Physics (12th Edition)
Life in the Universe (4th Edition)
Glencoe Physical Science 2012 Student Edition (Glencoe Science) (McGraw-Hill Education)
University Physics Volume 1
Conceptual Integrated Science
- (a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss the difficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P=I2 RP = .)arrow_forwardTaking R = 1.00 k and = 250 V in Figure P21.49, determine the direction and magnitude of the current in the horizontal wire between a and e. Figure P21.49arrow_forwardA tungsten wire is used to determine the melting point of lead. A battery of 6.00 V is attached to the ends of this wire and a current of 2.000 A is measured at 20°C. The lead is heated until it starts to melt. The tungsten wire is placed in the environment of the melting lead and the current is measured to be 1.237 A using the same 6.0 V battery. What is the melting temperature of lead? O Tungsten = 4.50 × 10-³ (°C)-¹. a. b. C. d. e. 132°C 157°C Comect 731°C 478°C 327°Carrow_forward
- A typical lightning bolt may last for 0.200 s and transfer 1.00 x1020 electrons. Calculate the average current in the lightningbolt.arrow_forwardOver the course of an 8-hour day, 3.8x104 C of charge pass through a typical computer (presuming it is in use the entire time). Determine the current for such a computer.arrow_forwardAn electric device delivers a current of 0.5 A for 10 seconds. How many electrons (1.6x10-19C) flow through this device? Select one: O a. 2 O b. 20 O c. 200 O d. 0.31x1020 О е. 3.1x1020arrow_forward
- Calculate the rate of the flashlight’s energy consumption. Suppose a flashlight has 6.8 × 102 C of charge pass through it during time 0.35 h. A. What is the rate of the flashlight’s energy consumption, in watts, if it operates at a voltage of 3.00 V?arrow_forwardConstruct Your Own Problem. Consider a battery used to supply energy to a cellular phone. Construct a problem in which you determine the energy that must be supplied by the battery, and then calculate the amount of charge it must be able to move in order to supply this energy. Among the things to be considered are the energy needs and battery voltage. You may need to look ahead to interpret manufacturer’s battery ratings in ampere-hours as energy in joules.arrow_forwardA charge of 4.00 C of charge passes through a pocket calculator’s solar cells in 4.00 h. What is the power output, given the calculator’s voltage output is 3.00 V?arrow_forward
- The starter motor of a car engine draws a current of 190 A from the battery. The copper wire to the motor is 6.97 mm in diameter and 1.10 m long. The starter motor runs for 0.939 s until the engine starts. How much charge (in C) passes through the starter motor? 178C is the correct answer. How far (in m) does an electron travel along the wire while the starter motor is on? Assume that the electron density of copper is 8.5 x1028 m-3.arrow_forwardThe charge (0.075 yC) stored in a component in your calculator is released and flows through a resistor in 1 millionth of a second (1 x 10^-6s) . Calculate the current that flows through the resistor and use it to calculate the resistance of the resistor. The calculator is powered by 4 AAA batteries in series, each 1.5 V, so the total voltage across the resistor is 6 V. Round your answer to the nearest tenth of an Ohm.arrow_forwardI need help understanding this question and the concept of it. A battery-operated car utilizes a 12.0 V system. Find the charge the batteries must be able to move, in megaCoulombs, in order to accelerate a 750 kg car from rest to 45 m/s, make it climb a 2.14E+02 m high hill, and then cause it to travel at a constant 27 m/s by exerting a 5.00E+02 N force for 55 minutes. Use g = 10 m/s2, if needed. This is a problem that connects the work, energy, and power concepts of Physics 1 to work/energy in electrical systems.arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College