Find the bandwidth and center frequency of the band-stop filter of Fig. 14.89.
Figure 14.89
Find the bandwidth and center frequency of the band-stop filter shown in Figure 14.89.
Answer to Problem 59P
The value of the bandwidth
Explanation of Solution
Given data:
Refer to Figure 14.89 in the textbook.
Formula used:
Write the expression to calculate the impedance of the passive elements resistor, inductor and capacitor in s-domain.
Here,
Calculation:
The given circuit is drawn as Figure 1.
Use equation (1) to find
Use equation (1) to find
Use equation (2) to find
Use equation (3) to find
The s-domain circuit of the Figure 1 is drawn as Figure 2.
Write the general expression to calculate the transfer function of the circuit in Figure 2.
Here,
Refer to Figure 2, the series connected impedances
Therefore, the equivalent impedance is calculated as follows.
Simplify the above equation to find
The reduced circuit of Figure 2 is drawn as Figure 3.
Apply voltage division rule on Figure 3 to find
Rearrange the above equation to find
Substitute
Substitute
Refer to Figure 3, the input impedance is expressed as,
Substitute
Substitute
Simplify the above equation to find
At resonance condition, the imaginary part of the impedance should be equal to zero. Therefore, equate the imaginary part of the above equation to zero.
Simplify the above equation to find
Take square root on both sides of the above equation to find
Substitute
Simplify the above equation to find
Substitute
Substitute
Substitute
Simplify the above equation to find
At corner frequency
Substitute
Simplify the above equation.
Substitute
Simplify the above equation.
Square on both sides of the above equation to simplify it.
Simplify the above equation.
Simplify the above equation.
Assume
Write a general expression to calculate the roots of quadratic equation
Compare the equation (8) with the quadratic equation
Substitute
Substitute the roots of characteristic equation in equation (8).
Substitute
Simplify the equation (10) to find
Take square root on both sides of the above equation to find
Simplify the equation (10) to find
Take square root on both sides of the above equation to find
Write the expression to calculate the bandwidth of the band-stop filter.
Here,
Substitute
Conclusion:
Thus, the value of the bandwidth
Want to see more full solutions like this?
Chapter 14 Solutions
Fundamentals of Electric Circuits
Additional Engineering Textbook Solutions
Electric Circuits. (11th Edition)
ELECTRICITY FOR TRADES (LOOSELEAF)
Electronics Fundamentals: Circuits, Devices & Applications
Fundamentals of Applied Electromagnetics (7th Edition)
Microelectronics: Circuit Analysis and Design
Electric Circuits (10th Edition)
- Q.3/ Find the difference equation that describe, the following digital filter: M (Z) E (2) 27²-3.52 +1.9 2²³²-2.77² +Z-0.95arrow_forward14.38 Find the resonant frequency of the circuit in Fig. 14.78. Figuro 14 78 L m C ww Rarrow_forwarddetermine the transfer function Vo/Vi of the RC circuit of Fig. 14.68. Express it using wo=1/RCarrow_forward
- O-- 5. What input voltage results in an output of 2 V in the circuit of Fig. 14.46? I MQ 20 ka Figure 14.46 Problem 5arrow_forwardElectrical Engineering Design a low-pass, high-pass, and band-pass filter based on the following schematic selecting your own values for components. Analyse the circuits in frequency iden- tifying center and cut-off frequencies. Build and verify the operation of the circuit based on the designs. V_L+ VC+ V_Lref V Cref VR+ 10.0mH 5.0µF Vin R1 5V Vout 500HZ 10.00 V Rrefarrow_forwardAnswer the following with illustration and solution. 1.) Calculate the frequency of this low-pass filter given a resistor value of 1.2k ohms and a capacitor value of 4.7 microfarad. This is ithe example that might help.arrow_forward
- Determine the center frequency and bandwidth of the bandpass filters in Fig. 14.88. ΤΩ ww 1 H (a) ww IF (b) IF ΤΩ www ΤΩ 192 IHarrow_forwardIm + Re -100 -1 Figure 1: We want to sketch the bode plot for this filter! 1) Rewrite H(s) in the "standard form" for Bode plots 2) Using paper + pencil, sketch the Bode magnitude and phase shift plots. 3) What kind of filter is this: Low-pass Bandpass High-pass Notcharrow_forward14.22 Find the transfer function H(@) with the Bode magnitude plot shown in Fig. 14.74. H (dB) A 20 O -20 Figure 14.74 For Prob. 14.22. 2 -20 dB/decade 20 100 w (rad/s)arrow_forward
- Example 21: A series R-L-C circuit has R = 102, L = 0.1 H and C = 8 μF. Determine, (i) Resonant frequency (ii) Q-factor of circuit at resonance (iii) The half power frequenciesarrow_forwardDesign second order high pass filter to find the value of capacitors if R1 = 23K, R2=11.5K and the cut of frequency is 1KHzarrow_forwardWhat is the cut-off frequency of the filter below, if the resistance is 0.33 kOhm and the inductance is 100 nH? L1 my INPUT OUTPUT R1 Figure 2. RL-filter 125 MHz a. 2.5 MHz b. 525 MHz C. 25 MHz d.arrow_forward
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,